XbeasleyX
04-15-2004, 02:21 PM
I'm no novice at customizing things but I milled out my Spyder(back-up) , took out the back of the top tube until 1/2in before the farthest the last o-ring goes. Now it is double firing, I checked the edges of the sear and hammer and both are sharp, then started changing springs to see if it helps, but I looked and only had about 900psi in my tank, dont know if that was causing the problem or not because I've been in games and shot below 700 and it worked fine. Did my mod screw it up or am I just a complete idiot whos just low on air?