View Full Version : Hiding RTP rail holes with Emag jewel
I was thinking about getting a custom e-mag jewel to cover those nasty holes that the front grip rail attaches to. My qestion is if an e-mag jewel will cover all three holes? Anybody that can check?
CaliMagFan
04-26-2004, 11:47 PM
joni...
what about putting the screws from the rail back in... i removed my site and grip rails and i think the silver screws have a snazy highlight quality... just my $.02
-kyro
Yeah, might be nice, but I would rather have some nice jewels. It'll look better, and if I'm not mistaking, frymarker makes custom jewels.
Could someone just measure their E-mag jewel? That's all I need.
FreakBaller12
04-27-2004, 06:08 AM
2 inches long :)
rkjunior303
04-27-2004, 07:38 AM
Rogue,
When you do your next milling batch for your rails, you should mill a small jewel pocket there for a "Roguefactor" jewel ;)
2 inches long :)
Ok thanks. That means that the jewel covers the holes just fine.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.