View Full Version : HALO-B Z-Code issues?
Dayspring
04-28-2004, 09:54 AM
I've seen a few people in my local area have problems with their Z-Coded Halos.
The problem I mean is that I, and a few others, have snapped the spring retention part of the drive cone. Is this a common thing?
I know I have to replace it either way, just curious to see if this is just me.
Curly
04-28-2004, 10:22 AM
Yes, it is my understanding that this is something that has been happening quite often. Mine has yet to snap though.
Load SM5
04-28-2004, 10:28 AM
Mine snapped before I got the Z-code installed. I think it just happens to all of them at some point. There's a lot of pressure on that teeny bit of plastic. I'd recommend greasing up the belt. It takes a little bit of the force off without sacrificing much in the way of speed.
Torbo
04-28-2004, 02:28 PM
doesnt have anything to do with z-code. My teammates just broke, but hes had it for about 2 years so i guess its ok. Its just a 5 dollar part anyway.
Dayspring
04-28-2004, 02:44 PM
Try $15. They don't sell it on their site without the spring and the disk underneath the cone.
Load SM5
04-28-2004, 02:50 PM
That kind of upset me too. I bought a drive cone from them at the Memphis Indoor for $5 but when I went to buy a spring, a few weeks later ,I had to buy the whole drive package for $15. Apparently you can buy the small parts by themselves, if you catch them at events, but not online.
Torbo
04-28-2004, 03:25 PM
single parts are available from dealers, not direct from the company.
RRfireblade
04-28-2004, 08:42 PM
Had one break too but I think it was before the Z code update.The other Halo B I had broke something else before that had a chance to. ;)
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.