View Full Version : E mag warp left ULE body loose...... why?
captain stabbin
05-01-2004, 05:05 PM
Hi i just got back into mags all- And when i take my X valve out of my emag- i can almost shake the body around; how do i correct this... A.k.a where are the screws to tighten the body in- im almost afraid to remove the grip frame because i have terrible luck with lost parts.
Chronobreak
05-01-2004, 05:11 PM
the whole gun is held by two screw the filed strip in the back that hold the vavle and abck fram e then the front frame screw that holds the body and grip on as well most likely the front needs to be tightened or a new screw if its stripped
captain stabbin
05-01-2004, 06:05 PM
im aware of the field strip screws im not that much of a noob hah- but thanks, however ive owned mags in the past and when i take the valves out of them- the bodies still dont wiggle around like this one... any other suggestions ....
Like he said, it's the trigger frame screw that needs tightening.
Tunaman
05-01-2004, 06:42 PM
maybe the front :confused: screw is too long...
Chronobreak
05-01-2004, 11:09 PM
anything funky with the frame milling to fit the ule? even tunaman seems bit puzzled
Enemy
05-02-2004, 01:54 AM
check to make sure the frame screw isnt stripped thats all it can be unless your ule body or rail have some defect!!!!
SpecialBlend2786
05-02-2004, 02:13 AM
yeah, maybe your front screw is stripped or something... thats strange.
captain stabbin
05-02-2004, 10:21 AM
thanks guys, got it all worked out- screw just needed to be tightened... and i couldnt tighten it to how it needed to be because my allen key was stripped in that size... got new ones; all good.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.