making the air valve

[steveg]

Hi AGD/Tom by chance do you have pictures that you
could show everyone on how the A.I.R. and RT valves
are manufactured.

[steveg]

strange I guess no else is curious about how it's done

[AGD]

Well its not very interesting I'm afraid. A bar of stainless steel feeds into this half million dollar lathe, a few minutes later a little door opens up and the part rolls out. No kidding.

AGD

[HyperSnyper]

I use to always think that if you were a good little boy or girl, if you left your Blow back gun under your pillow, the AGD fairy would replace it with a Mag there for when you wake up.

Now I dont feel so special... sigh...

[steveg]

darn I wanted to see what brand of turning center and barfeeder that was used. professional curiosity you see