Question about hoppers

[nameless143]

Hello everyone! I am new to this board and I just got my first automag, an Rt Pro ;) . My question is, what hopper should I use? I was thinking either an Evo II or one of those new Riccochet Apaches that can do 17-19 bps. Any other ideas or opinions will be very much appreciated!

[68_Classic]

it all depends on how much u willin to spend on it.. i would say either a evo 2
or a halo

[shivors]

I would say the Empire Reloader B. Sound activated means no sensor to go wacko on ya and it runs as fast as a Halo (without victory).

[Adrenaline_Junkie]

Id say Evo 2. Its fast enough that you wont outshoot it and it is way lighter than a Halo. If your not concerned with weight go with a Halo Reloader B.

My personal favorite is a QLoader but they cost a tad bit more than the other hoppers i mentioned.

[nt2004]

Halo if you have the cash. I've heard theres a lot of problems with evo feed necks and viewloader shells in general. But i guess the halo has its problems too. Personally, I believe the Halo is worth the money.

[johnnybravo60025]

I would say go Q-loader or Z-boarded egg.

[Adrenaline_Junkie]

What he said^^^

[68magOwner]

apache, 2 friends have eggs, i have an apache and halo, the halo is what i usally use, but the apache is light, faster than eggs, holds alot of paint (compared to halo) has game timer, has smaller profile than the tegg, better customer service than egg, more origional, ect, get an apache ofer the egg for shure

[Torbo]

unless you have real fast fingers, a 12 volt rev will be fine for ya. with level 10, youll be fine. If you want extra speed, definatly a halo, or Reloader B. I prefer the Reloader B, but its pricey. Id still recommend a revvy though, because the others are kind of unnecessarily fast/expensive for a mech gun.

[11_Mile_TMaster]

I use a Halo B on my RT-Pro, have yet to outrun it. The Halo also has the advantage of a small buffer of shots where the gun doesn't have to be right side up.