PDA

View Full Version : warp feed testing


raider_o1
10-10-2001, 10:06 PM
I read somewhere that AGD had tested the warpfeed w/ around 30 volts and produced a large volume of paint flow. I need to find this, please help.
Cha0tic
10-11-2001, 04:46 AM
well, they had a modular emag with warp shooting 20bps, done by John Sosta. is that what you are talking about?
raider_o1
10-11-2001, 11:39 AM
It was an article about the warp feed. I thought that it was on the AGD or WARPIG sites but I was unable to find it. It talked about how the warp feed used 6, 9, or 18, volts and put out so many balls for each. Also talked about AGD testing at a high voltage to determine max output. I was trying to figure out if i could rig up 12 or 18 volts and get a significant improvement.
Potatoboy
10-11-2001, 11:43 AM
They must have used a specially modified warp. From the AGD Warp Manual: "Never put more than 12 volts into the system! Doing so will blow the board."
raider_o1
10-11-2001, 11:49 AM
Are the 10volt rechargables available?
BlackVCG
10-11-2001, 11:55 AM
AGD Europe has them.

http://www.airgun.com/Europe/AirgunShop/page1.htm
raider_o1
10-11-2001, 12:03 PM
What are the chances of getting some in Alabama?