z-board

[dragun_30]

is it pretty simple to install z-board in the Evo II? and how do you do it?

[-=Squid=-]

is it pretty simple to install z-board in the Evo II? and how do you do it?
VERY simple. Just take all the screws out of the egg, then remove the old board and pop the new one in. Put back togethor. Yup, thats all.

[dragun_30]

ok, thanx alot

[Prezents]

For the most part all you have to do is remove all the screws on the body and then remove the 2 lid screws and the 2 springs.
Open the battery lid and slowly pull apart.

look to see how the board is still in the loader, how the motor is setting where all the clear parts go.

Just remove the old board and install the new one.
You will have to remove the motor plug from the stock board and plug it into the z.


It is easy dont make it hard on yourself.
Good luck

[Hellaspaint]

Pay attention to put the plug in the right side, not opposite, because the motor will drive the paintballs out of the feed tube.