new micro e-mag FULL AUTO?

[irs709]

i just recived my micro e-mag today, and ive been testing it w/o air, and i figured out its fully auto. and the shots on the counter go up fast

[ClassicMagger]

Hey:

You probably have some of the older emag software. I don't remember which one it is but one of them allows you to shoot in full auto. Or it might of been the emagnum board.

-ClassicMagger

[Prezents]

You might have the jumper on that allow's full auto on.

[Flossabe]

I think that was 1.1 that was full auto, not sure it needed a jumper, my jumper just activated burst, that is when i had 1.37. you may also be experincing bounce, are you fimilar with e-mags? Also with micro E-mags the on/off pin is a real monster, if it is not set right for that specific micro e-mag it can make it go full auto all of the time, wait you arnt using air are you, hmmm, not sure, but if you do have any micro e-mag problems let me know, i have had to deal with a fair share with no help. Hope you enjoy it.

[Flossabe]

Ok everybody that wants one, I have decided that as dificult as it will be If people want them real bad I will try to make them while I am gone, it will take a little longer but you will not have to wait four months. so if you want let me know.

[irs709]

i think it was cause the batt was low. thx

[Flossabe]

sweet, hope you dont have any more problems, what software do you have on that by the way?

[irs709]

i have 3.2 :headbang: