Bad_Dog
06-19-2004, 11:14 AM
Hey all,
With the predicted arrival of my emag comming up, I've been thinking...
I currently run a warp setup with my intelliframe, when I get my emag, I'm going to swap everything over to that... will I need a special wiring harness to hook my emag up to the warp?
if so, how much would it cost? where can I get one?
any help is appreciated!
Thanks,
~Kyle
With the predicted arrival of my emag comming up, I've been thinking...
I currently run a warp setup with my intelliframe, when I get my emag, I'm going to swap everything over to that... will I need a special wiring harness to hook my emag up to the warp?
if so, how much would it cost? where can I get one?
any help is appreciated!
Thanks,
~Kyle