snatch grip

[elpimpo]

anyone know where i could pick uo a nice black snatch grip for my timmy? i have to replace that back screw and i figured id get a snatch grip to go along with it

[Blazestorm]

www.paintballgateway.com

Have fun :D

[coolcatpete]

Someone needs to make a few of these for mags :clap:
Pete

[Blazestorm]

Definately, but you'd need a longer back screw, otherwise it might not fit :)

[coolcatpete]

Definately, but you'd need a longer back screw, otherwise it might not fit :)
It wouldnt be to hard to find those same threads just longer in the hardware store.
Pete

[elpimpo]

you think this would fit my 2k2 http://www.paintballgateway.com/checitdraggr1.html

[coolcatpete]

you think this would fit my 2k2 http://www.paintballgateway.com/checitdraggr1.html
I think it should.
Pete

[Fatjon]

go to paintballkingdom.com Its the offical timmy parts site. Has everything you could ever need for a timmy

[zacbot]

what are the point of these things?..

[elpimpo]

easier to tote your gun around

[OysterBoy]

See I actually use the snatch sometimes, when I had one rigged on my mag it was great when I played front, Id hold the back end and just book it. Worked great.

[elpimpo]

yeah ive seen points start off the break holding the snatch

[Automaggot68]

I've seen one style of snatch for the Newer shockers, and if you had a longer rear screw, I think it'd work pretty well. I dunno, that was jsut me looking at it on paper. i think it was the talon grip?

[coolcatpete]

See I actually use the snatch sometimes, when I had one rigged on my mag it was great when I played front, Id hold the back end and just book it. Worked great.
Where did you get the snatch for your mag, I want one now.
Pete

[bleachit]

Where did you get the snatch for your mag, I want one now.
Pete


why not just make one?

[coolcatpete]

why not just make one?
Because I am incompitent and bad at making things with metal.
Pete

[bleachit]

good enough, I guess.

[coolcatpete]

However if anyone want to make me one I would pay for one becasue it makes your gun super AGG.
Pete

[OysterBoy]

Mine wasn't very pretty, but it did just fine; I took an angeled PMI ASA ( a flat duckbill would work) and widened the holes in the back of the rail, then sunk the holes in so the screws would be flush with the rail. Then I just used some nuts under the asa to hold it in place, looked pretty nice. :cheers:

[The Frymarker]

I have a question about these, that maybe you could answer, do you think resin would work well as a snatch grip???


I was thinking of the pewter route but just wanted to know.

[OysterBoy]

If your asking me, I'd say anything stronger then the same grade plastic used in the common revy (new). This is an estimate, but it doesn't take much abuse so it should hold up. In terms of looks/flow, Resin would probably look a little nicer. Either or.

Unless you weren't talking to me, which wouldnt be a surprise. :tard:

[The Frymarker]

I was asking anyone who wants to answer :)

I was thinking the transparent resin would look neat as well and would weight less


Hmmmmmm :cool:

[elpimpo]

whenever someone says resin i never think of the plasticy stuff