On/Off Leak

[TheLaxPlayer]

When I gas up my marker, I hear a hiss. It is a classic valve. I believe the cause of this is the on/off assembly. When I gas up the marker, the pin gets pushed out of the assembly about 1/8". When this happens it is a constant leak, and I cannot remove the valve from the body without removing the trigger frame and pushing the valve back in.

What can I do to fix this problem?

[jknospe]

Check the conditions of the O-rings for the on/off (replace if warn) and add a couple of drops of oil to the assembly.

[ß?µ£ §mµ®ƒ]

try shooting the gun a couple of times, i had a problem like this, it was weird and wasnt sealing, mine had something to do with pressure and oil on my on/off oring

[Bossman21]

I have the same problem, my on/off looks ok, o-rigns are ok, the gun still leak, when i pull the trigger it stops leaking but when the trigger is in normal position it leaks again ... i realy don`t know whats the problem ... help :cry:

[Dayspring]

If you are pulling & holding the trigger, the leak isn't in the on/off.

Replace the orings in the powertube.

[Bossman21]

I replaced the powertube o-rigns, lubed it and it still leaks ... i`ve never seen that before, looks like the pin of the on/off is jamed ... when i turn on the pressure it leaks if i hold the trigger it dosen`t , the on/off is in perfect condition , any ideas ? i might buy an X-valve but if the problems comes from the on/off im losing 225$ instead of 30$ ... this automag RT pro is my 1st gun so im a total newb :rolleyes: but i know how it works ... help ?

[Dayspring]

Wait- this is a new RT Pro. Does it have the level 10 installed?

[JT Pimp]

Are u guys running regs? or like a low pressure out-put nitro tank? Also check o-rings on on/off assembly.

[Bossman21]

I dont have a level 10 installed, i have a 68/3000 HPA tank, RT dosen't work with co2 , i've unmounted the on/off the o-rigns are ok, same problem ...

[jknospe]

Check out Havoc's Website (http://www.havoc-online.com/). Maybe his "Classic & RT" section can help. If not, have on one of the AGD tech's check it out. Its easier to debug a problem with the marker and spare parts at hand.