Phase
07-17-2004, 12:01 AM
While I was reassembling my classic mag after taking it apart to work on my rail, I put my on/off pin in backwards. I didn't know at the time but when I gased up my gun, everything was good but when I fired and held the trigger, it leaked just like it would as if an o-ring was damaged. I don't believe its the o-rings that caused this because they were just recently replaced but do you think the pin being in backwards could have caused this? :confused:
After that I ran out of gas so I couldn't really test it again but I did gas it up after putting it back in correctly and it didnt leak but it was low on gas so I dont know if that was truly the problem. Any opinions are appreciated. Thx
After that I ran out of gas so I couldn't really test it again but I did gas it up after putting it back in correctly and it didnt leak but it was low on gas so I dont know if that was truly the problem. Any opinions are appreciated. Thx