View Full Version : Does a e-mag grip fit on a minimag?
Haynballa
07-19-2004, 09:57 PM
Hey every1 just was wonder'in if a emag frame(grip) fits on a minimag?
Haynballa
07-19-2004, 10:38 PM
uuuuuuuuuuuupppppppppppppp
notcreative
07-19-2004, 10:38 PM
no, you have to get a new rail
Cryer
07-19-2004, 10:39 PM
Hey every1 just was wonder'in if a emag frame(grip) fits on a minimag?
the trigger frame?
I imagine it would... the only thing is, getting a whole Emag frame (electronics, solenoid, et al) would cost about as much as getting a nice, used, complete Emag...
Enemy
07-19-2004, 11:04 PM
have to switch rails as well!!! oh and on/off pins plus i wouldnt put it on a classic valve that would not be very good as the soleniod is so large!!
afultz075
07-19-2004, 11:12 PM
Plus a minimag body won't fit on an emag rail unless it's modified.
Cryer
07-19-2004, 11:15 PM
long story short...
just buy an emag ;) :p
vf-xx
07-19-2004, 11:42 PM
If you really want the minimag style body on an emag the best way to go about that is to buy an emag and a minimag body and then have the minimag body modified.
It can be done. I'm currently running a minimag body on my RTP without any problems at all.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.