PDA

View Full Version : Those with ULE center fed bodies


Carbon Blue
07-20-2004, 02:04 AM
Hey whats up!? I currently have a smoked 12v revvy with an x-board on it. Im currently looking at the chrome or black ULE main body with the center feed. My question is that how do you guys with the vl 12v revvys keep the hopper onto the center feed tube? can those straight elbows work? thanks
Setzer
07-20-2004, 02:48 AM
Hey whats up!? I currently have a smoked 12v revvy with an x-board on it. Im currently looking at the chrome or black ULE main body with the center feed. My question is that how do you guys with the vl 12v revvys keep the hopper onto the center feed tube? can those straight elbows work? thanks

I use a 2004 Rogue Strangler Feedneck (http://www.automags.org/forums/showthread.php?t=136290) . Works awsome
Halliday
07-20-2004, 09:00 AM
I don't use an elbow. A unsanded Rev fits in the stock feedneck very snug. I've replaced mine with a CCM Clamping neck.
afultz075
07-20-2004, 09:03 AM
How do you get off the stock feedneck by the way? I'd like to replace the stock feedneck on my ULE body with a Rogue Neck since the stock one is scratched up.
Halliday
07-20-2004, 09:13 AM
Heat (from a hairdyer) and a rubber strap wrench (from a hardware store)
252
07-20-2004, 09:59 AM
My pre BE revy fits in there just fine.
Cryer
07-20-2004, 10:36 AM
CCM lowrises are better than roguenecks ;)
Carbon Blue
07-20-2004, 12:15 PM
Heat (from a hairdyer) and a rubber strap wrench (from a hardware store)

so u just set the dryer onto high heat and blow the heated air at the stock feedneck and twist away?
Carbon Blue
07-20-2004, 12:16 PM
CCM lowrises are better than roguenecks ;)

do you know where i can buy a CCM low rise? thanks for all your help cryer
Halliday
07-20-2004, 12:58 PM
so u just set the dryer onto high heat and blow the heated air at the stock feedneck and twist away?
Pretty much. It may take a few minutes of heat.
funkmunky56
07-20-2004, 01:14 PM
hell, I just use a bic lighter, and heat up around the base of the feedneck for a lil bit... then twist off with a strap wrench, or a piece of rubber, or a washcloth for that matter. the black stuff from the lighter wipes right offa anno and nickelplating. and you dont' hafta mess around with a hairdryer. --Funk