emag intellifeed cable

[meshaq]

i need an intellifeed cable for my emag by sunday, and dont have the time to order one from AGD. i was thinking if i took the mode jumder wire, and cut it in half, then connected a intellifeed wire to each part, it would be an intellifeed wire. does anyone know if it will work or if i will have any problems?

[jknospe]

For the warp to emag board, you need a 2 terminal connector. See PC Board (http://www.airgun.com/xmag/html/pcboard.html) diagram.

[meshaq]

i found away to make your own emag intellifeed wire. i made an intellifeed wire, then took the mode jumper, cut the 3 slots off the connector so it is just the brown wire and the slot that it is connected to. then i cut that inhalf and connected each end to an end of the intellifeed wire.