"here's my old blue pneuma-sear mag"

[GT]

I think this guy used to post here on AO.



http://home.kc.rr.com/theelectrician/magsideview.jpg




the reg on the blue mag runs pressure to the valve installed behind the trigger, which controls the ram in the grip that pulls the sear down. so now the trigger pull is 1 mm @ about 8 ounces of force.
just a wee bit lighter than stock(3-6 lbs)



http://www.pbnation.com/showthread.php?threadid=18777&perpage=40&pagenumber=10

[Cool fool!]

how can this be done???

[Skoad]

i'm guessing a magic spell.........


he says how its done.

[Automaggot68]

That The electrician's mag. he's since made it electro

[GT]

That The electrician's mag. he's since made it electro

why would he do that?

[Koosh]

yeah, The Electrician posts here quite often... or if he quit, he's quit fairly recently.

"Made into an electro" means making the E-frame from scratch... check in The Workshop forum every now and then...

[warbeak2099]

It's like a simplified version of the HAIR. In fact, I'd rather have that one.

[the electrician]

why make it electro?

because....I can.

seriously though, my pneuma-sear design had run it's course. where as it was a reliable and fast set-up, it was missing the control I really wanted. but I'll tell you this, the orginal design was pretty cheap and easy to put together.it was like instant speed for the classic. didn't really need a lvl 10 with that set-up, it was pretty reliable in the no chopping department.
I specifically remember throwing a stream of paint at a friend, who ended walking off the field, with paint on him and his matrix. ;)

kuddos in that department go to Nicad though. the hAir trigger is the most imppressive mechanical/pneumatic trigger I've ever seen.

read the whole story of that gun here:
http://www.automags.org/forums/showthread.php?t=125891&highlight=finally+finished

it looks completely different now.it's almost a full pound lighter now.
no more metal-flake blue acrylate urethane either.
new all black theme. black ULE, CCM clamping neck, new drop, and a milled rail. I need to get the rail, shroud, and grip anodized to match the ULE body, and then take some pictures of it.
it's a fun gun to shoot.

[Linkwarner]

all I have to say is, "How much?"

[minimag03]

I'll take one of the cheap ones :D . How much are they again?

minimag03

[SpecialBlend2786]

hmmies.....looks interesting.


how much?! :clap:

[warbeak2099]

Yea, how much to do that version of a pneu mod?