ULE warp body

[StormSurge]

I just saw a note on the agd site about the ULE warp body. It said that the body needed "slight" modifications. I was just wondering if "slight" translated into "costly machining" of the rail to fit the feed tube.

[Bad_Dog]

It all depends if you have the proper tools and a steady hand... I've done both of mine with a dremel and a small file, doesnt take too much since its aluminum. But then again if you're a person who'd prefer to have someone else do it professionally the modification can be done by almost any machinest... Its a simple cut that doesnt require any odd angles so the cost is usually kept down.

[AGDlover]

its just small notching. i did my emag rail with like 3 different bits with my roatery tool

[StormSurge]

kool beans