View Full Version : pure energy low pressure spring pack
fire1811
08-09-2004, 08:54 AM
anyone know where i could get one of these?
some where you know they are in stock would be appriciated.
thanks
curt
soccer4minimags
08-09-2004, 09:23 AM
For the tank reg or their inline reg?
For the tank as far as I know the bevel washers controll pressure. You lower or increase it by adding or removing them. They come in a parts kit that I have only seen sold directly through PMI. Basically it was enough parts to completely rebuild your tank reg, including an extra set of washers.
fire1811
08-09-2004, 09:24 AM
its for the tank reg
it replaces the spring pack
soccer4minimags
08-09-2004, 09:28 AM
edited above post
fire1811
08-09-2004, 10:27 AM
so is it safe to remove some of them?
just called pmi and they have the low pressure kit but they cant sell it directly
soccer4minimags
08-09-2004, 04:28 PM
why do you want to lower the output on your pre-set anyways? Are you trying to by-pass an inline reg?
Take your reg apart and look. You make the call. I havent done it myself. I have taken it appart many times though cleaning out stuck pin valves.
I cant really see any danger in this, anything you do is after the burst disks. Call a pmi tech and ask them what exactly you should do.
fire1811
08-09-2004, 04:33 PM
i need to lower it for my angel speed.
you are supposed to input 4-500psi into the minireg.
i am inputting 850psi right now and with the minireg mod(flipping/removing spring stacks)
i can only get my velocity to 298fps. thats too close to the limit.
either way i found a site that has these in stock and ordered one. it will bring the preset down to 480-500psi depending on how i set it up.
so basically for $26 i now have a fixed low pressure and high pressure tank.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.