Powertube Orings

[Carbon Blue]

I plan on changing these since theyve been in the gun for about 3 years already and had some co2 run through them. I currently run a Bulldog 3 setup with a preset of 800psi right now. The gun shoots great(i always put oil down the powertube tip) but i was thinking it would be regular maintenance to change those orings out. I know i take a coin and twist the powertube tip off. Do the orings just fall out? do they have to go back in specific order? should i clean anything else while im at it? thanks

[Carbon Blue]

nevermind i was able to find an exploded view of the valve, BUT do i just drop those orings into the powertube when im done oiling/replacing them?

[TheShark]

Where did you find this exploded view?

[Carbon Blue]

http://www.automags.org/forums/showthread.php?t=133976&highlight=exploded+view

check the AGD ONLINE store for a better exploded view.

[Tunaman]

nevermind i was able to find an exploded view of the valve, BUT do i just drop those orings into the powertube when im done oiling/replacing them?Push it all the way down flat in the powertube before putting the spacer in. ;)