View Full Version : trigger job on benchmark 2 finger
micah fallaw
10-23-2001, 08:56 AM
Anyone know how to make the stroke on a benchmark 2 finger trigger frame SHORTER?
Thordic
10-23-2001, 09:04 AM
Some of the aftermarket frames may need a trigger rod adjustment to work correctly...
HOWEVER, without exact specs and a caliper, it's very hard to do yourself, and you stand a good chance of screwing up the gun.
Messing with the trigger rod yourself is not a reccomended thing to do, it's best to get it done. Go buy an airsmith some beer and make friends :)
a_malfunction
10-23-2001, 10:30 AM
You could install a trigger stop.
I would recommed malfunctions tip. A trigger stop will help a bit. It will get rid off that nasty loose on the trigger. And it's not very hard to do that.
I did this a while back. It works pretty well.
http://choad.virtualave.net/paintball/trigger.html
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.