Thinking about morlocking my micro emag. Any tips?

[_KFC_Chicken_]

Ok, anyone who has done it, will you please tell me what to expect?

Is it hard setting it up? what about the sensor thing vs micro switch?

With the ball detent in the middle it might be hard to ACE?

I can solder good enough to do the wiring, and the other option I got is to wire in an Edwin ACE chip I got.



:confused: $120 on morlock+ACE and use 9 volts, or $90 on battery charger and $20+ on 4.0. :confused:

[warbeak2099]

If you use breakbeam eyes it won't be hard to ace. Breakbeams are placed towards the bottom of the breech. They'd probably be right under the detent on a micro.

[chirogator]

pm blackvcg, he may know something about them.

[TheMagMan]

Had 1 .. been there and they are the most sensitive of guns to pop one of those boards in. If you have no experience with micro's and the specs, get a ton of help or have someone else do it for you. Every recoil shot on my micro e caused it to shoot again and again before I finally fixed it. I mainly used the mech part of the gun. Oh and I had to replace the solinoid (sp) due to a burn out. TheAngelGuy.com had some for sale a while back for $89. PM BlackVCG for any tech info if you need it.

Good Luck



http://www.automags.org/forums/attachment.php?attachmentid=21009

http://www.automags.org/forums/attachment.php?attachmentid=9510

http://www.automags.org/forums/attachment.php?attachmentid=21008

[_KFC_Chicken_]

Haha, maybe I should just pay $85 for the charger.

Is there any 9volt adapter for the emag? I want to at least test the gun!

[TheMagMan]

Haha, maybe I should just pay $85 for the charger.

Is there any 9volt adapter for the emag? I want to at least test the gun!

Even if you rigged something up I don't think it will provide enough constant flow.
I may be wrong, people have a nice way of being creative on these boards. :D