hyperframe questions

[evo.end3R]

hey im getitng a hyperframe with 20bps board and 50 gram microswitch. do i need to use a ULT with it or can i use the stock xvalve on/off?

[evo.end3R]

anyone know??? :confused: :confused:

[68magOwner]

i thought hyperframes came wiht there own sear pin, and mabey own on/off assymbley

[SOAD8789]

hehe, evo, lemme help u out...since you would be getting the hframe from me....it does come with an on/off assembly that is supposed to help, but the ULT works better. lemme show you something....

http://www.automags.org/forums/showthread.php?t=150181 that is why the ULT helps. fyi, the centerflag on/off is crap. the ULT will help, A LOT. they sell devilmags with the ULT and a hyperframe with the same software as the one im sellin u.

[Ohms Law]

The ULT on/off is a must have for reliable operation with the Hyperframe.

[hitech]

The hyperframe comes with it's own on/off bottom and pin. You can get the hyperframe to work with this on/off. If you are using a level 10 valve only the short spring may work. Also, the on/off pin length is "finicky". The ULT on/off assy. solves both of these problems and is a better solution.

Hyperframe FAQ (http://www.automags.org/forums/showthread.php?s=&threadid=79328)
:cheers:

[GA Devil]

hehe, evo, lemme help u out...since you would be getting the hframe from me....it does come with an on/off assembly that is supposed to help, but the ULT works better. lemme show you something....

http://www.automags.org/forums/showthread.php?t=150181 that is why the ULT helps. fyi, the centerflag on/off is crap. the ULT will help, A LOT. they sell devilmags with the ULT and a hyperframe with the same software as the one im sellin u.


No not close to the same software. Totally different board.

[spyder56]

where can i get just the 20bps board? i have the 13bps already?

[gc82000]

Check the Dealer forum they will help you out.

[Hairball]

Buy that frame and Devilmag it. >: D