rt mag will not shoot

[dj89]

I know this should be in the Tech Forum but I need it working buy tomorrow so plz let it stay here


ok the deal I got this old rt mag. It had a gay dobble trigger :rolleyes: so I milled my singer so it would it fit than I put lvl 10 in it.

well when I air it up it shoots once with out me pulling the trigger than when I pull the trigger it dose not shoot :confused: :cry:

plz help me I will be on aim all night

[cloud113]

Well when I air it up too my gun shoots by itself sometimes and even does a 3 shot burst sometimes which I have gotten used to, but if it doesn't shoot again maybe it's the bolt sticking forward? If that's the case just take off your hopper put a finger down there and push it back. Can't really think of anything else hope it helps :).

[dj89]

thats what i was tinking to to but nope :( . frist time i can't find out whats wrong with my mag :( :cry:

[RTDynaflow]

What does it sound like/what happens when you pull the trigger? Little more info... I would take off the trigger frame and put the old one on. If the problem continues to happen you know it's not there.

odd are it's the level 10. did you install it? Ever installed one before?

Is it leaking air?

I bought an older RT about a month ago and probbably have had every problem imaginable so far...

[dj89]

i'v put lvl in in all for my mags that did not have it.

i have 3 other mags.

i'll try the old frame

[dj89]

it works with the old frame do you think it could be the sear should i trun the sear out or in?
to get it to work with my single?

[RTDynaflow]

turn the pin in the sear counter clockwise (out). it is probably just not fully tripping the sear

[50 cal]

My RT had set too long without being shot. The on/off seals had gotten a bit sticky. It would only shoot one shot and that was it. I took out the on/off and the seals. Lubed the seals real good and re-installed all the on/off parts.
It took a few times of working the on/off pin to get it to work right.
The on/off pin was a little too short by a few thousands and it would full auto. Kinda cool.

New on/off pin and all is well.

[magmonkey]

before messing with the sear, did you turn the velocity up after the level 10 install?

[dj89]

it works with the old trigger frame

[dj89]

it was the sear thanks guys



AO can fix anything ;)