Trigger Slop

[ryanshep]

Well i just traded my vik for a sweet ule e-mag and im loving it...... :eek:

anyways, its got a Lt-3 trigger on it. The trigger has a lot of trigger slop and i can get 1-3 shots per pull because of it. Is there anything i can do to stop this? i think if i messed with the shot buffer it might be able to do something but im really not sure which way means less bounce. I also noticed that the trigger pin that holds the trigger in place isnt quite all the way in, if i was to push this all the way in would it take away some slop? Thanks for ur help

-ryan

[jewie27]

get a 10/32 bit and drill a hole in the trigger shoe and put in a trigger stop.

[ryanshep]

slop meaning rocking from side to side....i dun see how a trigger stop would effect that.... :confused:

[AGDlover]

how many mm's are we talking side to side? if anything if its soo bad you can pop out the trigger pin and put small spacers out of a erector set and pop em in

[ryanshep]

its a good 1-2 mm's... i would do that if only i had an erector set :cry:

if worse comes to worst ill just play with it its not that bad........ :cry:

[AGDlover]

then run to your local hardwear store and pick up some small warshers/spacers

[jewie27]

not spacers, shims would work. i read wrong that's why i said trigger stop.

[AGDlover]

don't use shims because even though there thin they have too big of an opening so they would slide out every which way. just o to the hard wear store and get some washers

[ryanshep]

or ill just leave it how it is, oh well

thanks for all ur guys help

[athomas]

You can buy round shims. They look just like washers only thinner. If not, get some shim stock and drill and cut your own shims. I have shims in my trigger assembly and it really tightens up the pull. It makes it much more crisp and predicatable.