ULT installation help

[rkim210]

Can anyone elaborate in detail w/ pics on how the ULT is properly installed? I read the sticky, but it doesn't tell me exactly what piece goes where. Thanks.

[Dayspring]

Well, when you get it from the factory, it's prtty much already installed for you. Just take the old on/off assembly out with the top orings and put the ULT in.

You just have to unscrew the top from the bottom to put the shims in. It's not tough at all.

[rkim210]

Where is the on/off assembly exactly?

[Janitor]

Here is a link for an exploded view of an RT valve hope this helps.
rt valve exploded view (http://store.airgun.com/index.cfm?fuseaction=catalog.prodInfo&productID=201&categoryID=22)

I know it is hard to see in that view but it will make sense when you get it. It also come with some directions to help you out.

[Dayspring]

Take your valve out. It's the brass square piece underneath the valve. It just pulls out. (On an Xvalve). In a classic valve, it's the round part undernath. Same procedure applies.

[rkim210]

Did anyone of you guys have extra o-rings left over after you installed the ULT? I have a small black one, a small white one, and a big white one left over. It shoots fine, but I don't know if they go somewhere.

[Eatem Alive]

they are spares