FireBlades are HERE!!! (woohoo)

[CoolHand]

They're Here!!!!!!!!

Having done my happy dance, I layed them all out, and took some pictures:

Big Jumbled Pile:

http://www.logicpaintball.com/Jumble.jpg

Random layouts to see all the sides:

http://www.logicpaintball.com/Group.jpg

And again (little closer this time):

http://www.logicpaintball.com/GroupClose2.jpg

View of the tops, and backs:

http://www.logicpaintball.com/BacksNTops.jpg

Now here is a nice close view of every side of just one:

http://www.logicpaintball.com/SingleCloseMontage.jpg

Check the dealer's forum for pricing and whatnot. (http://www.automags.org/forums/showthread.php?t=139517&page=4&pp=40)

Go get em fellas.

:ninja: Announcement

[Temo Vryce]

Very Shiny. :headbang:

Nice work.

[Z-man]

Looks like you did some milling to the area the sear pin touches. Can I see a close up with that?

[jayloo]

Mine is ordered :headbang:

[CoolHand]

Looks like you did some milling to the area the sear pin touches. Can I see a close up with that?

Yeah, I did. All it is, is a Letter I (0.272" Dia) drill bit mark, cut 0.035" or 0.040" deep (can't remember, not going to dig out the prints ;) ).

I took the average clearance (or lack there of) that most folks experienced with the first batch, and just cut a divot that deep for the rod to go into. Its just like shortening the rod, but a lot less work for the consumer.

Hopefully, they will still work in manual mode. :wow: :rofl:

(Note: That was a joke, there should be no problems)

[felony]

makes me want an emag again

sigh

i miss my emag

:cry: :cry: :cry:

[BetaMax]

Sweet. Mine is ordered.. Hopefully I'll get it before next friday. Got a tourny on 9/26.

[RRfireblade]

They're so pretty. :D