Emag runaway trouble

[evo.end3R]

hey my set up is emag lowers, rtp rail, xvalve with emag on.off assy, lvl10. i cant stop it from running away . it runs away and then the bolt sticks forward when it stops and jsut leaks air....what should i do?? :confused:

[evo.end3R]

it happens in both electric and hybrid mode..

[50 cal]

Sounds like your on/off is too short.

[evo.end3R]

i called AGD and they told me to buy the emag onoff assy wtf! i can try putting the quad oring on my rtp on off i guess...

[Tunaman]

Did you measure the pin? Does the sear show any signs of wear? Is your rail bushing in? Is the large oring present down in the on/off hole? Let me know and we will get it fixed for you.;)

[evo.end3R]

hmm maybe its b/.c i dont have the large oring i just had the quad oring...iwas thinking maybe it needed sometihng like that...

[evo.end3R]

ok so iput the bigger oring on too and it still isnt working right

[Tunaman]

ok so iput the bigger oring on too and it still isnt working rightis it still going full auto?

[evo.end3R]

no now its just not shooting argh sometimes it shoots but then it will stop and not shoot at all like the sear isnt working or some**** rrrrrrrgh