how would i do a flatline to mag setup like this?

[Omicron]

hey,

hopefully you can help me answer this question. How can I setup a flatline to a mag like the following picture? Is it possible? Thats my apocalypse to mag right now:

http://www.hunting-pictures.com/members/paintballjunkie13/air%20to%20mag%20setup.jpg

PS: Does anyone know when the 4500 PSI flatline will be out? or the Delrin Bolt?

[n1mr0d]

Easy....just a 1/8NPT 90 degree elbow and a 1/8NPT fill nipple. Plus the slide check and push on fittings etc....

[datapimp69]

take the slidecheck off it is killing your flow.

have you ever looked at the hole that the air goes through?

its like a pin hole

just a suggestion

[n1mr0d]

nothin a dremel can't fix :D

[BlackVCG]

Take off the slide-check and transfer your elbow in the Apocalypse to the output in the Flatline. The FL comes with a cradle and mounting screws so just bolt it right on. Put the quick disconnect at the elbow on the valve and thread the other end of the hose into the elbow on the tank. Now when you go to degas the gun, just turn the tank on/off to off, fire a few shots and pull the quick disconnect at the valve to relieve the rest of the pressure. When you go to oil the gun, disconnect the QD and drop 4-6 drops of oil in the female end of the QD, reattach it and gas it up. Cycle it 50 times and your gun is now oiled.

[datapimp69]

when you oil the gun rember to take the barrel off

makes a nasty mess in there