HyperSnyper
10-31-2001, 12:15 PM
Hello all (again),
I remember a thread a while back about Tom wanting to create a new valve system that would completely eliminate chopping by limiting the max fire rate to about 11. I was thinking (when I thought about the SmartValve) can a lower operating ressure be used to slow down the bolt cycling, thus reduce chances of chopping?
I know the smart valve only reduces the pressure marginally, but is it possible to bore the air chambers insides more to allow for more volume?
I remeber when I first wanted to get a Mag, I was in the world of LP Spyders. I talked to AKALMP, and Aaron there (the owner) climed to have a 300 psi Mag. He said he had an early valve where the powertube could unscrew, then he could grind away material from there to get hi LP setup. He claimed it worked great and shot straight.
Just wanted to know wht the moderators or MR. AGD himself thought about it? Let me know fellahs. Thx in advance.
-HyperSnyper
I remember a thread a while back about Tom wanting to create a new valve system that would completely eliminate chopping by limiting the max fire rate to about 11. I was thinking (when I thought about the SmartValve) can a lower operating ressure be used to slow down the bolt cycling, thus reduce chances of chopping?
I know the smart valve only reduces the pressure marginally, but is it possible to bore the air chambers insides more to allow for more volume?
I remeber when I first wanted to get a Mag, I was in the world of LP Spyders. I talked to AKALMP, and Aaron there (the owner) climed to have a 300 psi Mag. He said he had an early valve where the powertube could unscrew, then he could grind away material from there to get hi LP setup. He claimed it worked great and shot straight.
Just wanted to know wht the moderators or MR. AGD himself thought about it? Let me know fellahs. Thx in advance.
-HyperSnyper