Center Flag help please

[eaglelox]

my &*%$# hyperframe wont turn on.yes i tried a new bat. i have been searching on line but am unable to find anything but the whole frame. i would like to find different chips if they have them. thanks in advance for the help

[tasker89]

HyperFrame boards are available direct from CenterFlag. Contact us at 630-553-2611 and we will put you in touch with a tech to help diagnose your problem. I believe the replacement boards sell for $99.00. The new board is "semi-only" with a 20 BPS cap.

[Joni]

If the replacement board is 99$, I would seriously consider installing a morlock board instead. 110$, no cap on cps, ability to install eyes. Just need to be a little handy with the soldering iron.

[tasker89]

The Morlock board is certainly an option if you want an aftermarket board. However, too my knowledge. the Morlock board requires custom installation and set-up. $99.00 for our board is the installed price. CenterFlag will service and support a frame with the factory components installed. If you elect to use an aftermarket board, you will be on your own. Either option is viable.

[eaglelox]

i was just calling CF. but they are not open yet. were are they. i thought the east coast. 3 hours ahead.

ahh.P.O. Box 148YorkvilleIllinois two hours ahead

[eaglelox]

i have been calling all morning, left messages then called at 7:01 and missed the teck . he just steped out. wait he just started 1 min ago. :wow: i will try again tomorrow. i have to go to work. all day

ok im done with my whine now

[hitech]

Make sure the other end of the battery wires (where it plugs into the board) is plugged in. Unplug it and then plug it back in and see if it helps.

Also, make sure the trigger is not "pulled" when you turn it on.

:cheers: