rgt
11-06-2004, 12:09 PM
Hall sensor is in. I have it bent the correct way. When I test it with the trigger, it goes ON, OFF...etc. when pulling the trigger. When I try to install it, it istouching the frame an staying ON.
Is there something to do like put a piece of electrical tape infront of the sensor?
I have the sensor bent in such a way that when installed, it shouldn't hit the frame...but something is (I think it's the bare wire part of the sensor)
Is there something to do like put a piece of electrical tape infront of the sensor?
I have the sensor bent in such a way that when installed, it shouldn't hit the frame...but something is (I think it's the bare wire part of the sensor)