losing air through gun -help !!

[esox]

Help – Just bought a used RT Automag. Worked fine when I tried it out before buying it, but when I got home and tried to install the air tank, all the air would just leak out through the gun. Took off the tank tried holding in the trigger and reinstall the tank and the same results. Just about emptied the tank trying to attach it. What could be wrong with either me or the gun that I’m doing?
Thanks
:cry:

[Little_Ho]

Hi
make sure you have enough gap between the Trigger and the Searpin. I had pretty much the same problem at the last game. And i figured out that the adjustment was to close. So the Trigger was pushing the on/off pin allready in a bit.
Maybe the Lvl X??

Don`t know what else to say

Little_Ho

[Carbon Blue]

Go to the biggest carrier that does not leak. After that install the least amount of shims

[athomas]

Chances are, the sear is worn a bit causing the bolt to sit too far forward. If the gun has a level 7 bolt, then use a shorter powertube spacer.

[esox]

Thanks for your help guy’s, the only problem I have is there is no manual and I’m not sure exactly how to make these adjustments that you refer to. I have downloaded the information that was available from the AGD web page but I can’t find this info.

[Little_Ho]

Hi here is the link for the manual and blow up diagrams side on AGD:

http://www.airgun.com/manual.shtml

Manual for the RT:
http://www.airgun.com/Images/rtmanual.pdf

Here the RT (ReTro) Valve exploded view:
http://www.airgun.com/downloads/retroexploded1.pdf

Hope that will haelp you out to identify the Parts...

Little_Ho