yakitori
11-16-2004, 06:41 PM
Hi, I have a dilemma. I built a mag, and it has a classic rail, sear, and pin. It has the ASA, and an intelliframe. I am using my old emag valve w/ a ULT kit installed in it.
I was trying to use my old SS emag PF left body w/ my warp feed cause it fits nice and neat w/ a very small section of hose, and it looks very tidy. Anyway, I am having trouble getting the body to seat inside the rail right. It seems as though the rail is not milled out enough for the front body screw. I Can try one of two things.
A. Grind down the rail a little where the body screws in
Or. Grind down the SS emag body a little bit where the body screw goes.
OR if anyone has a Black SS warp left or PF left Classic Automag body I can buy it from them.
Thanks
I was trying to use my old SS emag PF left body w/ my warp feed cause it fits nice and neat w/ a very small section of hose, and it looks very tidy. Anyway, I am having trouble getting the body to seat inside the rail right. It seems as though the rail is not milled out enough for the front body screw. I Can try one of two things.
A. Grind down the rail a little where the body screws in
Or. Grind down the SS emag body a little bit where the body screw goes.
OR if anyone has a Black SS warp left or PF left Classic Automag body I can buy it from them.
Thanks