View Full Version : Intelliframe Question
PaintballingHockeyMan
11-19-2004, 01:59 PM
How do you change a standard double trigger on an intelliframe to a blade trigger?
After you get the replacement trigger knock out the pin holding the trigger in with a center punch or a nail, just make sure you use some cloth or tape around the hole so you don't scratch or nick the frame.
One side of the pin is slightly larger to keep the pin in, knock it out from the other side.
PaintballingHockeyMan
11-19-2004, 02:31 PM
Ok, thanks alot, I will try that.
:)
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.