PowerFedMag
11-05-2001, 05:47 PM
Hey, I was messin with my RT, and I took off the rear trigger frame screw (which was VERY tight), that holds in the RT Valve. I notice that it has O-rings and a hole, so I assume, when you screw it into the RT valve, it must line up to provide correct air flow or something. BTW, my screw pin is round.
So, I screwed it in really tight like it was, but couldn't tell if the holes were in correct postion.
When I next gassed up my gun, the trigger sputtered and fired about 5 or 6 times, then it stopped. I tried de-gassing and gassing up a couple times, and it seemed fine.
Today I gassed up, and my trigger fired off once. That was it. Tho I think my macro\micro whatever lines were leaking then. But after gassing up and later on they weren't.
So, I screwed it in really tight like it was, but couldn't tell if the holes were in correct postion.
When I next gassed up my gun, the trigger sputtered and fired about 5 or 6 times, then it stopped. I tried de-gassing and gassing up a couple times, and it seemed fine.
Today I gassed up, and my trigger fired off once. That was it. Tho I think my macro\micro whatever lines were leaking then. But after gassing up and later on they weren't.