dougs
11-05-2001, 06:14 PM
I just got my Emag upgrade back last week and got it all gassed up and ready to shoot over the weekend. I actually read the manual and watched the video (okay, it took me 2 to 3 sessions and a lot of rewinding to the points where I fell asleep) to see how it all worked and how to set it.
However, there are some things missing from my mag and from the manuals/video.
1. The jumper to make the Emag select fire is missing from my new gun, so all I can do is single-shot and not have the option to go select-fire or even full-auto. (I have emailed AGD today, so I'm sure I'll get an answer quickly and hopefully the jumper). I know the likely-hood of ever being able to go full-auto probably won't happen at any public game, but I would like the option of knowing how to set the jumpers up.
I've seen the little video of it shooting full-auto without using the Warp-feed, so I know it is possible, and assume it is just by putting the wire to a different pin on the 6-prong connector (of which you use 2), but I don't want to burn out my board or cause any dammage to "my baby." Anyone know the correct pins to hook up?
2. Rate of Fire - I see I can adjust the ROF from 6 to 15 balls (I think that is the range), but why would I adjust this? Especially since I can only fire one ball per trigger pull. If I set this value to the low end, is it more possible to chop a ball or something? Any advantages to setting to either the MAX or the MIN value for semi-auto play?
3. Anyone know where to get some neoprene so i can make a battery cover? I don't want it getting all beat up. I tried fabric stores and the hardware store, but no luck.
cheers
doug
However, there are some things missing from my mag and from the manuals/video.
1. The jumper to make the Emag select fire is missing from my new gun, so all I can do is single-shot and not have the option to go select-fire or even full-auto. (I have emailed AGD today, so I'm sure I'll get an answer quickly and hopefully the jumper). I know the likely-hood of ever being able to go full-auto probably won't happen at any public game, but I would like the option of knowing how to set the jumpers up.
I've seen the little video of it shooting full-auto without using the Warp-feed, so I know it is possible, and assume it is just by putting the wire to a different pin on the 6-prong connector (of which you use 2), but I don't want to burn out my board or cause any dammage to "my baby." Anyone know the correct pins to hook up?
2. Rate of Fire - I see I can adjust the ROF from 6 to 15 balls (I think that is the range), but why would I adjust this? Especially since I can only fire one ball per trigger pull. If I set this value to the low end, is it more possible to chop a ball or something? Any advantages to setting to either the MAX or the MIN value for semi-auto play?
3. Anyone know where to get some neoprene so i can make a battery cover? I don't want it getting all beat up. I tried fabric stores and the hardware store, but no luck.
cheers
doug