E-mag Power Problems

[Remington]

I was recently disassembling my E-mag and removed the board and power wire from the frame. However, as I was doing this, the power wire came off of the back of the board! :( I tried soldering it back on, but now it won't power on. I'm looking for suggestions for what my next step should be. Should I send it into a tech to have them repair it or is there something I can do myself? Thanks for the help!

[Tunaman]

Bah! Dont mess around with it. Send it here and I'll fix it. Make sure you dont short out the board. Disconnect the battery and leave it off till its fixed. ;)

[Cyberious]

If you got any solder that dripped in the wrong place you may have shorted out the board. If you're luck then it just crossed something up. Re-check the solder to make sure that it isn't crosssing something over causing a short. Unfortunately if you shorted the board they are pretty expensive to replace.

[Remington]

Great. :rolleyes: I'll be sending you an email shortly Tuna.

[Tunaman]

The boards are pretty durable. Keep your chin up. :D