MOds 4 warp feed

[B.A.M.]

I m going to do a big cell w/ on/off swith and can someone please tell me what parts and tools i need and instructions on how to do it. THx

[trains are bad]

you need some of the little 9v battery holders. You need some kind of switch. I like the littlest toggle switch at radioshack. To do it right you need a soldering iron and solder. Then wire it up like this. You can put the switch wherever you want.

[B.A.M.]

so do i connect the black wire between the 2 9 v or no and do i need a regulator

[trains are bad]

yeah I kinda have a break in that one line, use your imagination. No you do not need a regualor unless you are going for a 12v mod which in a waste in most cases.

[B.A.M.]

but wont it just be puting 18 volts in the warp and so do you just connet the 2 red wires from the thing the 9v connects to the switch and the other red wire to the other side of the switch and connect the 2 blacks then connect it to the black one from the warp

[trains are bad]

No, it will only be putting 9 volts in if you wire it up like that. It will have more, shall we say, balls though and last a lot longer on batteries.


so do you just connet the 2 red wires from the thing the 9v connects to the switch and the other red wire to the other side of the switch and connect the 2 blacks then connect it to the black one from the warp

If I understand you corretly, yes.

[trains are bad]

THIS would be 18v

[Havoc_online]

http://www.havoc-online.com/11575.html

section 10 :cool:

[B.A.M.]

thx ya i just looked at that after i posted and i now understand but do i just take the red and black wires from the existing 9v clips

[B.A.M.]

so do all i need is the red and black wire, 2 9v clips and a switch. Also were do i get heat shrink tubing.

[trains are bad]

You can get all of it at radioshack. You don't acrually need different colors of wire and you can use electrical tape instead of shrink tubing. It's up to you.

[B.A.M.]

Alright my parents just ordered my warp for X-mas so ill go down to radio shack sometime soon

[B.A.M.]

While looking at my gun i was wondering if you can some how make a halo b run of a 9v from my warp. IS it possible cuz i do know that it does take 9v (6AA*1.5).

[trains are bad]

It's possible.

[B.A.M.]

Has any one ever done it

[trains are bad]

I have.

[B.A.M.]

did you just run two wires from one of the 9v's in the warp and attach it to the wires from the halo

[trains are bad]

dude, I'm not going to try to explain it over the internet. It's simple electricity. If you don't know how to do it you shouldn't be doing it, even if I gave you step by step instructions, you should get a good understanding of what you're doing, so that you can see mistakes before they occur.

It shouldn't be hard to figure out, at all.

[B.A.M.]

WEll i just went to Radio Shack and picked all the part for the mods. I had a little trouble at striping the wires but i got the job done. I did the INtellie hook up and the big cell mod thx to havocs pics.