View Full Version : CF Automag Mainbody & eV II
My eV II fits into my new CF Automag Mainbody perfectly; however, it's not tight enough and my loader swings back and forth worse than John Kerry. I've tried putting different tapes on the feedneck (Scotch, teflon, medical) but they all seem too thick.
Has anyone else encountered this and found a solution?
drewrw
12-09-2004, 10:17 AM
what I did was i took some scotch tape and cut the width in half. Also, i put it about half way up the feedneck on the evo and it works fine. And one more thing, dont put the tape all thw way around the feeneck of the loader. Only put it half way around like from one seem to the other. :dance: that should work for you.
I'll give it a try...thanks!!
drewrw
12-09-2004, 10:24 AM
no prob :headbang:
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.