View Full Version : hi question about warp system intelli feed
moed59
12-15-2004, 12:40 AM
Hi guys i have a 12v mod clear warped with a plug for my intelli feed switch, my question is how would it work if i didnt have an itelli with switch, is there i way to change it, or does it have to run with the intelli and switch?
it will still run on its own
moed59
12-15-2004, 01:46 AM
when i have batteries in it nothing happens and there is alittle button when i push it runs other wise nothing????????????????? thanks
Tunaman
12-15-2004, 06:07 AM
make sure the jumpers are in the correct position and adjust the sensitivity. ;)
Doobie
12-15-2004, 07:21 AM
make sure the jumpers are in the correct position and adjust the sensitivity. ;)
What Tuna said. You have to adjust the sensitivity of the sensor. For everything Warp, visit Havoc_Online's site (http://www.havoc-online.com/11575.html) , that should help!
jewie27
12-18-2004, 07:35 PM
The Warp also has a vibration sensor. Setup the jumpers in the right position and set the sensitivity.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.