Z-man
12-24-2004, 05:37 AM
While making a new thread might be a little excessive, it will cut down on the number of times I have to link people to this info ;)
Many people wanted to know how the QLoader was mounted on top of the marker (many people also took the time to mention that this setup was not very low profile... for speed testing I guess). All we did was snag one of my extra Warp adaptor (the one found on the AGD store)
http://store.airgun.com/index.cfm?fuseaction=catalog.prodInfo&productID=69&categoryID=19
To make it fit properly on the Qloader socket I stuck it on the lathe and turned it down a little. We used electricians tape to tighten up the connections on each end. That is really it.
http://www.zakvetter.com/image/linked_images/warp_adaptor.jpg
http://www.zakvetter.com/image/linked_images/qloader-end+adaptor.jpg
Many people wanted to know how the QLoader was mounted on top of the marker (many people also took the time to mention that this setup was not very low profile... for speed testing I guess). All we did was snag one of my extra Warp adaptor (the one found on the AGD store)
http://store.airgun.com/index.cfm?fuseaction=catalog.prodInfo&productID=69&categoryID=19
To make it fit properly on the Qloader socket I stuck it on the lathe and turned it down a little. We used electricians tape to tighten up the connections on each end. That is really it.
http://www.zakvetter.com/image/linked_images/warp_adaptor.jpg
http://www.zakvetter.com/image/linked_images/qloader-end+adaptor.jpg