Sear question

[chairman_mao]

This may be an ingnorant questino but I'm an ignorant guy so it werks out. Doe sthe type of sear you use depend on the rail it is set in or the valve it is used with? The practical application of this question is I have a AM/MM rail and I am putting a ReTro valve into the set up. The gun originally had a classic valve, am I mistaken in thinking that the sear doesn't need to be changed? All help is appreciated.

[Joni]

Your absolutely right.
AM/MM rail -> AM/MM sear
RTP rail -> RTP sear
regardless of valve

[chairman_mao]

Cool good lookin out and thanks for the speedy answer

[Airborne]

I have a question about the sear pin. On the karta rail the hole isn't big enough for the stock sear pin i have and it didn't come with anything to replace it. What am i supposed to do about that?

[JoshK]

Sand it down :)

[Airborne]

Sand it down :)


Are you serious?

[JoshK]

length wise or thickness is it not fitting? cause length wise just sand it.

[Airborne]

The stock sear pin is too fat for the hole in the karta rail. The hole looks like it's half the size of the pin. If i were to get a pin that would fit into the hole, the pin would be to small for it's hole in the sear. That's why i'm wondering what i should do. Would the smaller sear pin disturb my trigger pull?

[toymyster]

The sear pin is a 3/16" hardened metal dowell!!! You can get them in diferrent lengths, I think the stock is 3/4"(0.750) long, try a 1/2"(0.500)!! They are available at most machining and metal/ industrial supply places!!!! If the diameter is diferrent, you might have a defective rail, Call the DW guys, they'll take care of you!!!

[Airborne]

I'm new to this forum, and i'm just getting back into paintball after a year+ break. Who are the "DW Guys"?

[AnArchist_1944]

Here (www.deadlywind.com) are the DW AKA DeadlyWind Guys.

[danheneise]

guys i think he is trying to get a AM/MM sear to fit into his karta rail which is basically a milled rtpro rail. so there for he needs the rt sear, it should fit fine, don't sand or drill anything

[Airborne]

the sear i have is the one that came w/ my x-valve for my AM/MM.

[Tunaman]

Thats the wrong sear and pin for the Karta. You need an RT Pro sear and pin. ;)

[Airborne]

And that will work with my xvalve? Thanks a lot everyone, you've been a lot of help. I take it that i could pick one of those up on the airgun.com site?

[Airborne]

Is the RT Pro sear different from the AM/MM Sear? Or is the difference just in the bushing in the sear pin hole? If that's the only difference could i just buy a bushing and RT pro sear pin? Then put the bushing in the sear that came with my x-valve?

[Andrew Cunje]

rt has less side to side play, but remeber the difference is minimal...

but as described the r/t sear with this minimal play is faster than the 68 ones