Ule Warp Body

[usmc8892]

I noticed in the description of the Warp ULE Mainbody at airgunstore.com that it says "Warp ULE Mainbodies will require a slight modification in order to fit." Can anyone advise what this "modification" may involve ?

[stop whining buy a mag]

A notch must be carved into the rail allowing the feedneck to come out the side of the rail. It isn't too hard to do and there's plenty of people on AO that will do it for you.

[MonsterMag]

all you will have to do is pop out the twist lock assembly. No biggy

[stop whining buy a mag]

^^^That too, if you still have the twist lock assembly in there. Milling that notch out is just a more time consuming part.

[dj89]

all you will have to do is pop out the twist lock assembly. No biggy
And you have to cut a notch in rail i think.

[usmc8892]

carving out the notch...would that be something a dremel and some sandpaper can handle?

[dj89]

:eek: Yes if you must. :cry:

[Tunaman]

There is an easier way to do it. I have adapters that replace your feedneck so you dont have to mill the rail. Profile is a little higher but they work great.

[stop whining buy a mag]

Tunaman has everything to make our paintball life (For some of us, our only life) a little easier.

[AsianMiniMag]

I didn't have to notch out anything...all I had to do was take out the twist lock assembly....I have a logic milled rail...fits good.

[MonsterMag]

go with tuna's adapter ;)

[Little_Ho]

Hi there
thats the way i did it befor i get my moded Splinter Rail from Rogue....

http://mitglied.lycos.de/pezipezi/America/Paintball/Marker/Special%20Upgrades/IMG_3373.JPG

http://mitglied.lycos.de/pezipezi/America/Paintball/Marker/Special%20Upgrades/IMG_3376.JPG

Hope that clears your question......btw its a standart rail. All i used was a dremel and a litle bit on time.....


Little_Ho