probably dumb question

[GodLovesUgly]

but can i cut the power feed on a clasic mag, so that my hoopper doesn't stick out as much. and if so how would i go about doing that? i was thinking maybe a copper saw, but i wasn't sure if maybe i'd need a torch.

[Skywalker]

I'm sure you could do it, but it might not look too pretty when your done. Try a table saw or maybe a miter saw.

[rpm07]

It has been done in he past i think the people that did them used pipe cuters

[peewee]

I used a band saw. You only want to take off about 5/8.

[Mer]

You'll need something to cut stainless steel. Try to cut it about 1/16" longer than you need to leave a little room for clean up.

Measure twice, cut once!!

[BD_Paintball]

if you do this use a pipe cuter. my pump mags feed tube is cut down and it looks alot better

[slade]

I'm sure you could do it, but it might not look too pretty when your done. Try a table saw or maybe a miter saw.
?!! i hope that was a joke, because that is dangerous and almost impossible to do cleanly. use a pipe cutter. a hack saw would work, but it wouldnt be as clean.

[Creative Mayhem]

It can be done, I have done it. I used a hacksaw, marked of 5/8" +/-, cut, then filed the edges clean. Then I had the body chromed, but you can polish it.(I went the lazy way and paid for shiney ;))

[Lee]

dremel :D

[thelane]

:rofl: wow friend did that with a hacksaw and it looks ok but he kinda isint good at that stuff but I would use a pipe cutter then a file

:shooting: :dance:
-lane the flying skwril

[master_alexander]

i used a chop saw, then i sanded down the burrs with a dremel.

[Sk8ermog]

or you can just have Luke turn your standard feed body into a vert feed body like this:

http://www.rossgunniv.com/PaintballCollection/Decparts/offsetbody.jpg

It looks great and works even better. Gives you a clear line of site and you can still use powerfeed barrels on it. Click on the link in my sig about custom work to find out more.

[BeaverEater]

I would use a pipe cutter, or a hacksaw then sand down the edges to take off any possible burrs.