Chindi
01-14-2005, 02:40 PM
Hi all, need some help.
I have an old Level 7 'Mag. Ten years ago, I cut the trigger guard on the stock polymer frame and added a double trigger. Now that I am playing strictly rec ball and scenarios, I wanted to replace the grip frame and go back to a single trigger with a trigger guard.
I ordered an 'old-school' aluminum trigger frame from airgun.com, and it arrived today. I went to put in on the rail, and immediately ran into a problem. The spring that was in my polymer frame is too short to work on the older aluminum frame. With the frame on the rail, the spring slips easily out of place after about three trigger pulls. :confused: Obviously, this isn't so great.
Can I get a longer spring? Were the springs different sizes? Any other fixes? That spring isn't listed on the airgun.com store.
Thanks for any help!
-Chindi
I have an old Level 7 'Mag. Ten years ago, I cut the trigger guard on the stock polymer frame and added a double trigger. Now that I am playing strictly rec ball and scenarios, I wanted to replace the grip frame and go back to a single trigger with a trigger guard.
I ordered an 'old-school' aluminum trigger frame from airgun.com, and it arrived today. I went to put in on the rail, and immediately ran into a problem. The spring that was in my polymer frame is too short to work on the older aluminum frame. With the frame on the rail, the spring slips easily out of place after about three trigger pulls. :confused: Obviously, this isn't so great.
Can I get a longer spring? Were the springs different sizes? Any other fixes? That spring isn't listed on the airgun.com store.
Thanks for any help!
-Chindi