View Full Version : Anyone know who did the milling on this RAIL?
dahvaio
01-21-2005, 09:49 PM
I just received a ULE Rail that I purchased from AdaBita... and it was milled by someone and I was wondering if anyone knew the persons work.... Wanted to say great job on the milling...
I've included a picture of my Original RT-ULE rail and the one I purchased from AdaBita...
JadedT
01-21-2005, 10:26 PM
Looks like RogueFactor's work. Check out the dealers' forum.
Blennidae
01-21-2005, 10:30 PM
Might also be BlackVCG's work. He did some simillar work on a stock Emag rail I had.
RRfireblade
01-21-2005, 10:34 PM
Not me is all I can say. I don't go thru the bottom like that in the center section. Don't think Black does either.Not sure about the others.
Blennidae
01-21-2005, 10:52 PM
BlackVCG did go thru the bottom of the center section on my Emag rail.
RRfireblade
01-21-2005, 11:02 PM
oh, ok...then there you go :) Maybe.
Sk8ermog
01-22-2005, 06:28 AM
I know it's not Lukes cause he hasn't done one like that, but if you want to get a body cut like that or looking even nicer then check out Lukes work on my rails:
http://www.automags.org/forums/attachment.php?attachmentid=81440&stc=1
http://www.automags.org/forums/attachment.php?attachmentid=81607&stc=1
Check out my sig for more info.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.