View Full Version : Emag going FA
impact301
01-23-2005, 06:57 PM
I have a 3.2 emag and when ever I try and shoot it ends up going FA tried using both lvl 10 and lvl 7 bolts makes no difference. Everything is oiled up nicely and the battery is fully charged.
Any ideas?
TMAXXKING1
01-23-2005, 07:10 PM
is the screw on the trigger to close to the hall sensor try and back it out like a 1/4 a turn ..
impact301
01-23-2005, 07:24 PM
The on off is not sealing. It was mechanical FA not sure if I fixed it now though because I ran out of gas... Think I need to buy a new xring.
impact301
01-23-2005, 07:33 PM
Update switched the xring with brand new oring the is absolutely NO sealing happening what so ever I beleive the sear is not pushing the pin is up far enough how can I adjust this?
clb33fyxj
01-23-2005, 07:48 PM
check and make sure the pin isnt broken. my gun broke the pin in my xvalve for some random reason the other day and it would go f/a as soon as i put air to it.
chris
impact301
01-23-2005, 07:50 PM
Pins in perfect condition im prettry sure just the throw of the sear is off. Thanks for the reply tho could happen...
TMAXXKING1
01-23-2005, 07:55 PM
is the on/off the stock emag one .. if you changed out the valve .. to say from emag to x valve .. the emag on/off has to be in the valve or did you buy used lowers and toss what ever valve you have on the lowers..
impact301
01-23-2005, 08:01 PM
I did not just assemble this gun I have been using it for along time.... Its a stock ss emag valve. Do you adjust the throw of the sear where it screws into the solenoid?
impact301
01-23-2005, 08:37 PM
Its not the sear... the on off will not seal from some bizzare reason.
impact301
01-23-2005, 09:23 PM
Fixed, thanks tmaxx.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.