PDA

View Full Version : Rail tolerances.


JoshK
03-05-2005, 09:56 PM
Will it affect my rail's tolerences if I drill two holes at the back of the rail to attach a asa onto it? Thanks.
Tunaman
03-05-2005, 10:19 PM
It will be just fine. Dont leave any burrs that could space up the rail.
JoshK
03-05-2005, 10:28 PM
It will be just fine. Dont leave any burrs that could space up the rail.

Huh tuna...i dont get what you mean. Sorry if im ignorant :p
Tunaman
03-05-2005, 10:43 PM
Huh tuna...i dont get what you mean. Sorry if im ignorant :pIf you drill it from the top, like where the body sits on it there is a chance you could leave a burr or piece of metal lip from the drilling process that will stop the body from seating all the way down on the rail...just drill clean holes.
JoshK
03-05-2005, 10:55 PM
If you drill it from the top, like where the body sits on it there is a chance you could leave a burr or piece of metal lip from the drilling process that will stop the body from seating all the way down on the rail...just drill clean holes.


Ok thanks...I would have done that...im just not up to the lingo :)