PDA

View Full Version : Why do trigger stops void AGD warrenty?


Alpha
03-31-2005, 09:12 PM
Well? I couldn't figure it out... Any ideas?
master_alexander
03-31-2005, 09:27 PM
it does? oops... i would like to know this too... where did you find this?

also what if you just get another trigger?
warbeak2099
03-31-2005, 09:51 PM
If not set correctly, they could cause short stroking which would put more wear on the sear and bolt. I believe this is what they mean.
alooney11
04-01-2005, 01:14 AM
i use one on my logic frame,but dont adjust it to close, you need some slop in a mags trigger.
tony3
04-01-2005, 06:02 PM
They can mess up the sear, happened to me, my sear got all chipped up and the bolt wouldn't catch at high rof.
SlartyBartFast
04-01-2005, 06:14 PM
It's the same reason you shouldn't play with the length of the trigger rod.

Some slack MUST be left otherwise you risk not holding the sear open long enough and/or not letting the sear move up fully engage the bolt.
Alpha
04-01-2005, 10:04 PM
How much is some slack? A few millimeters of play?
noahyay
04-02-2005, 01:47 AM
the sear comes back up faster, or not down enough, then the bolt does have time to go back in place and the bolt has to push down the sear which chips the bolt and sear

look at an animation if your confused